Rabu, 30 Maret 2016

Bee Reset Honey Mead and Sterilizing the Hive Bodies

While our capers with shook swarming and wax rendering have been great, one other main benefit in pressing the reset button on our bees is the edible part.  We humans arent going to catch the foulbrood, so if the bees cant eat their honey, we might as well!  We just need to extract it.  Fortunately, this post will be a lot shorter than the others.  Heck, we can even throw in the sterilization of the hive bodies for good measure, and wrap this story up!

As a reminder, heres the overall process were working with.

We did the honey by a whatchagot version of the crush and strain method, since we were working mainly with brood frames, which meant honey around the outside, brood in the middle.  That is, we didnt want to extract whole frames, just select chunks of comb.  Our setup is two buckets; the top one has holes in the bottom.  A t-shirt goes between the buckets to strain out chunks of comb, etc., and the comb gets mashed with our hands and goes in the top bucket.  In this particular case, the bottom bucket also had holes, so the whole setup is in a cookie sheet for secondary containment.

Once the comb is crushed up, the honey will eventually drain out.  It took several days, but its a low-tech, low-effort system!  Of course, some honey will end up stuck to the comb (probably more than if we had a centrifugal extractor).  We washed the comb through with water, to recover any residual honey for making mead.  Some of the YouTube videos we saw in the research phase of this post showed people washing their wax before extracting it and just throwing out the water--so this is similar, but we keep the water for something tasty!

The water wont be concentrated enough to make a very strong mead as-is, so we added sugar to boost the final alcohol content (hence the name quasi-mead, since this stuff isnt made purely from honey).  Also, the wine yeast need more nutrients than just the (diluted) honey and the sugar can provide, and the mead will need some tannins to keep it from tasting like vodka or cough syrup (depending on how much residual sugar there is), so we added some very strong rose petal-and-raisin-tea.  We might forego the rose petals next time, since they didnt seem to be a very good source of tannins.  Hopefully well have a post soon on our approach to making fermented beverages.

Our final yield was about 4.5 quarts of honey, or about 14 lbs. (There is a quart jar-and-a-half missing from this photo because Katie is part pooh bear.)  Note that if you are extracting uncapped honey (as you may be doing during a bee reset), check the refractive index of it to make sure it has a low enough moisture content that it wont ferment in the jar.  Below 20% is normally the standard, but other sources say 17-18% is a better target.  Those other sources also say that if its a little higher moisture content than that, keeping it below 50 °F can also prevent spoilage.

Finally, sterilizing the boxes.  Some say to heat everything, especially the corners and other nooks and crannies, until the wood is a uniform deep coffee brown color.  The bacteria that causes EFB (Melissococcus plutonius, although it was originally called Bacillus pluton) is inactivated above 65 °C, which isnt enough to turn the wood brown.  But heating until the wood is a little charred is an easy visual to make sure were in the safe zone for killing EFB (and any other diseases that might be hanging around).  Sort of like roasting a giant wooden square marshmallow, but from the inside (the paint on the outside doesnt need to change color).  By far, the easiest and fastest way to do this would be with a propane blow torch.  But if you dont like the thought of all those difficult-to-recyclable propane canisters, you can get a similar effect with a little alcohol-fired camp stove.  Definitely not the OSHA-recommended protocol, but it works!

Once all the parts the bees have touched are uniformly charred (minus the extra-resinous parts, which saw the same heat, but didnt turn color), we should be good to re-use the box.

 How do you extract your honey and sterilize your hive boxes?

0 komentar to “Bee Reset Honey Mead and Sterilizing the Hive Bodies”

Posting Komentar

 

Aquaponics at Home Copyright © 2016-2022 -- Powered by Blogger